13
To change the belts, loosen the nuts securing the motor on the machine and move the motor
forward until you can remove the old belts and put a new set of belts on the pulleys. Move the motor
in order to tighten the belts in a suitable way. Make sure the pulleys are aligned correctly. Then
retighten the nuts to assemble the motor securely.
After the control or the change of the belts, always reassemble the belt guard.
Cleaning of the machine
Your machine will last longer if you clean it thoroughly after each day of work, especially motor and
blades or pan.
7 Faults: causes and cures
7.1
Fault-finding procedures
Should any fault occur during the use of the machine, turn it off, and isolate it from the electrical
supply. Any works dealing with the electrical system or supply of the machine can only be carried
out by a qualified electrician.
7.2
Trouble-shooting guide
Trouble
Possible source
Resolution
No electricity
Check the electrical supply
(fuse for example)
Connection cable section too
small
Change connection cable
Defective connection cable
Change connection cable
Defective switch
CAUTION : can only be solved
by qualified electrician
Motor is not running
Defective motor
Change motor or contact motor
manufacturer
7.3
Circuit diagram
