9
2.4 Technical Data
Electric motor
2,2kW 400V 3~
Electric motor protection
IP55
Max. tool diameter
900 mm
Rotation speed of the tool shaft
130 min
-1
/ 65 min
-1
Sound pressure level
79 dB (A) (ISO EN 11201)
Sound energy level
91 dB (A) (ISO EN 3744)
Type of tool
Blade or plate
Machine dimensions (LxWxH)
1980x950x1060mm
Weight (with tool assembled)
81 kg
3 Assembly and commissioning
The machine is delivered fully equipped. It is ready for operation after assembly of the tool and
adjustment of the machine arm, and after connection to the appropriate power supply.
3.1 Tool assembly
Only NORTON blades or plate with a maximum diameter of 900 mm can be used with the
CT901ME.
Before mounting a new tool into the machine, switch off the machine and isolate it from the main
source of electricity. Make sure the tools are not rotating anymore.
Screw 2 M6-screws per blade using a 10mm wrench to assemble the blade on the arm. To
assemble a plate, place the machine with the blades assembled on the plate, and turn it until the
blades are located in the hooks on the plate.
3.2 Electrical connections
Check that,
•
The main switch is on “0”.
•
The voltage/phase supply corresponds to the information indicated on the motor plate.
•
Available power supply must have ground connection in conformity with safety regulations.
•
The connecting cables should have at least a 2.5mm
2
-section per phase.
3.3 Starting the machine
Set the machine arm in a comfortable position. To that purpose, loosen the handle on the arm and
set the arm at the right angle, then retighten the handle.
To start the machine after connection to the power supply, set the main switch on “1” or “2”,
depending on the rotation speed chosen. If the machine is turning in the wrong direction, release
the dead-man handle, and wait the machine to be idle again. Then turn the main on on “1” or “2”,
depending on the rotation speed chosen, but in the other direction on the switch. Then press the
dead-man handle. To stop the machine, release the handle and set the main switch to “0”.
