Page 19
User Manual LineTroll R400D
Alignment
Correct alignment of the indicator on the pole is important to ensure correct operation.
Figure 9, Alignment
5. Event log
The LineTroll R400D has an event log where all events such as loss of voltage, transient and
permanent faults etc. are logged and time-stamped.
The LineTroll R400D also does internal checks in the firmware and store results of the checks
in the log.
The log stores the last 128 events and the log can be downloaded and stored in a memory
card and read/presented in a program on a computer.
This program is called NetLogger. Please find details about reading the log in the User Manual
for NetLogger.
The events that can be logged are:
✓
Power up reset
✓
Temperature (Logged every time the temperature is read)
✓
Connection to GSM Network
✓
Time set via external radio interface
✓
Line is energized (Loss of Voltage Reset)
✓
Line is de-energized (Loss of Voltage message)
✓
Indicator is reset after a fault by energized line
✓
Indicator is reset by timer
✓
Permanent fault alarm
✓
Transient fault alarm
✓
Indicator has detected fault current (Fault Start)
✓
Low Battery Alarm
✓
Time and position synchronization (GPS)
It is possible to set which messages should be logged and which message not logged by
configuration parameter as described in the configuration manual.
LineTroll R400D
LineTroll R400D
CORRECT
NOT CORRECT
