Note: If the touch screen LCD display needs to be unhooked from the NOS
Mini 2-Stage Progressive Nitrous Controller,
depress the lock tab on the male side of the connector as shown in the following images.
Unused Wires
As you finish the installation of your NOS Mini 2-Stage Progressive Nitrous Controller you may have unused wires. These wires need to
be properly taken care of before installation is considered complete. The preferred option is to remove them from the connector and
insert a weather proof plug in their place. The second option is to shorten the wire and properly seal the end of it to prevent shorting
out.
Option 1: Pin Removal (Recommended Method)
Required tools:
Small flat head screw driver
Pin removal tool # 567-101
Procedure:
1. Use a small screwdriver or other prying tool to gently remove the protective cover from the back of the connector. NOTE: Be
careful not to over extend the tabs on the cover or it will not securely fasten during reinstallation.
2. Gently insert # 567-101 removal tool into the small slot above the pin on front of the connector. It should not require much
fo
3. With the removal tool still inserted fully in the cavity gently pull on the wire to remove it.
4. If you will not be putting a sealed wire back in the cavity then you should now install one of the cavity plugs supplied with
tool 567-101.
5. Re-install protective cover on back of connector.
