NSJ0201 2 Ton Capacity Aluminum Service Jack User Manual
2
rev. 0070212
inSPECtion
Visual inspection should be made before each use of the jack, checking for leaking hydraulic fluid and damaged, loose or missing parts.
Any jack which appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED FROM
SERVICE until necessary repairs are made.
SEtUP
1. Depress the upper handle lock in the upper handle while simultaneously inserting the end of the upper handle in the lower handle.
Rotate the upper handle back and forth until the handle lock seats in the hole in the lower handle.
2. Unscrew the handle bolt so that it will not interfere with the insertion of the handle in the handle socket. Insert the handle in the handle
socket and rotate the handle assembly back and forth until the release valve fits in the receiver in the bottom of the handle. Secure the
handle in the handle socket by tightening the handle bolt.
3. Sometime air gets trapped in the hydraulic system during shipping and handling. If the pump feels spongy, or there is not a full
incremental pump stroke, or the jack will not raise to maximum height, follow these instructions in order to purge air from the system:
a. With the lift arm in its completely retracted position and the pump handle rotated all the way in a clockwise direction until it stops,
rotate the pump handle in a counterclockwise direction two full revolutions.
b. Proceed to pump the jack 15 full incremental pump strokes.
c. Rotate the pump handle clockwise until it stops and proceed to pump the handle until the lift arm reaches maximum height.
d. If the condition seems better, repeat steps "A" through "C" until all air is purged from the system.
Handle
Handle
Bolt
Handle
Socket
Upper
Handle
Lock
Lower
Handle
Bumper
Lower Handle
Saddle
Handle
Bumper
Handle
Socket
Handle
Rear
Casters
Chassis
Front
Wheels
Lift Arm
