nosstec 4135, Operating Instructions Manual

Operating instructiOns 4135

6

2013-05-23

safeTy

General

This bending roll machine is designed with a view to eliminating personal injuries provided that the in-

structions in this manual are being followed.
Only authorized and trained staff is allowed to use the machine. Read the whole instruction manual and 

make sure that you understand the contents before the machine is taken into use. It is important that 

you read the safety instructions below.

Safety instructions in connection with the installation

The machine must be bolted to the floor with  4 pcs expansion shell bolts diameter 16 mm. 

Electrical installation of the machine must be carried out by authorized staff.

Lifting instructions

This machine must be lifted by truck as long as it is 

packed in a crate or a wooden case. When lifting it 

from the packing  to the permanent working site an ap-

proved lifting device type travelling crane must be used. 

Instructions for lifting be means of travelling crane:
1.  Check that the top roll is in the locked position.
2.  Set lower and bending roll in upper position.
3.  Put a lifting sling around the rolls as per figure.
4.  Lift carefully at the same time as you check that the 

rolls are pressed together.

Regarding weights: see technical data

Dangerous area

The dangerous area of the machine is 

described in the figure.
This area shall in an appropriate way be 

marked in the floor.
A person staying in the dangerous area 

will henceforth be called “exposed per-

son” and the user of the machine the 

“operator”.

Operator,  

prebending

Operator

1,5 m

1,5 m

1,5 m

1,5 m