nosstec 4135, Operating Instructions Manual

Operating instructiOns 4135

8

2013-05-23

safeTy

Cut the power

Cut the current before touching live parts. This is done either by disconnecting the main 

switch of the machine or by disconnecting the voltage of the electrical cabinet. 
Note: Do not put the main switch or the safety switch of the machine out of operation.

Danger zone

In connection with production work check that no part 

of the body comes too close to the infeed side of the 

clamping rolls of the machine (see figure).
Note: The infeed side may vary owing to the direction 

of rotation of the rolls.

Keep the instruction manual of the machine in a safe place.

The instruction manual contains important information that besides the safety information also give 

important information regarding operation, service, maintenance etc.

Modification of the machine

All conversion, modification or change of this machine is strictly forbidden with the exception of
•  Original spare parts
•  Optional equipment supplied by the manufacturer.

Airborne noise

The following noise level has been measured at the operator’s place:
Equivalent noise level Leq, idle running 

66 dB(A)

Equivalent noise level Leq, operation 

68 dB(A)

Falling workpieces

Be careful when working with heavy workpieces so 

that they do not fall down by mistake  when the grip 

loosens between the upper and lower rolls (see figu-

re). If necessary use a support table, travelling crane 

or some other lifting device.