E
N
G
LI
S
H
12
CLEANING & MAINTENANCE
Follow the steps below to clean the keg tap and hoses. (see illustration below)
1.
Turn off CO2 completely before
attempting to clean.
2.
Remove the hose from the coupler
and carefully twist the dispenser
faucet off the top of the kegorator.
3.
Ensure that the dispenser handle is in the
down position before flushing the hose. If
this is not set correctly, water cannot flow
through. Hold the open end of the hose
under running water for 3-5 minutes, while
the beer dispenser faucet drains into the
sink. This will clear any excess beer that is trapped inside, helping to prevent any bacteria or
mold that could accumulate inside.
Follow the guidelines below to care for your kegorator when not in use.
•
Please adjust the temperature gauge to MIN in colder environments
because this unit does not self-defrost and ice may build up inside the unit.
The temperature control is located in the upper right-hand corner.
•
Always rinse the beer line if you do not intend to use your kegorator for a period
of time. First, turn off the CO2 and dispense beer until it stops. This will
release pressure in the keg so that the coupler can safely be detached.
•
To avoid permanent damage to the unit, never use sharp objects inside the kegorator.
Flush hose with water
2
Detach beer line
1
