Nostalgia Electrics KEG9000DTSS, Instruction Manual

E

N

G

LI

S

H

12

CLEANING & MAINTENANCE

Follow the steps below to clean the keg tap and hoses. (see illustration below)

1. 

Turn off CO2 completely before 

attempting to clean.

2. 

Remove the hose from the coupler 

and carefully twist the dispenser 

faucet off the top of the  kegorator.

3. 

Ensure that the dispenser handle is in the 

down position before flushing the hose. If 

this is not set correctly, water cannot flow 

through. Hold the open end of the hose 

under running water for 3-5 minutes, while 

the beer dispenser faucet drains into the 

sink. This will clear any excess beer that is trapped inside, helping to prevent any bacteria or 

mold that could accumulate inside. 

Follow the guidelines below to care for your  kegorator when not in use.

• 

Please adjust the temperature gauge to MIN in colder environments 

because this unit does not self-defrost and ice may build up inside the unit. 

The temperature control is located in the upper right-hand corner.

• 

Always rinse the beer line if you do not intend to use your  kegorator for a period 

of time. First, turn off the CO2 and dispense beer until it stops. This will  

release pressure in the keg so that the coupler can safely be detached.

• 

To avoid permanent damage to the unit, never use sharp objects inside the  kegorator.

Flush hose with water

2

Detach beer line

1