8
Installing the Casters
Follow the steps below to install the casters.
1. Empty the inside of the cabinet completely and lay
the KEGORATOR™ down on it’s side. We
recommend that you place a piece of cardboard or
cloth underneath the cabinet to prevent dents or
scratches.
2. Insert the casters into the holes on the bottom
corners of the cabinet. Tighten each caster
by turning the nut clockwise with a wrench
(not provided in the kit).
3. Once all four casters have been tightened,
stand the cabinet in its upright position.
Note
: Two of the casters include locking mechanisms to ensure the unit does not slide on
hard floors. These two locking casters should be fastened at the front end of the unit, with
the unlocked casters fasted on the rear end.
Installing the Beer Tap
Follow the steps below to install the beer tap.
1. Remove the cabinet plug located
on the work top. Firmly grasp the
cabinet plug, twist and pull upward.
Note
: Keep this plug in a safe place --
it will be required when using the
KEGORATOR™ as a refrigerator without
a beer keg in use.
2. There are notches on the
bottom of the draft arm
assembly that line up with
grooves inside the opening
in the top of the KEGORATOR™.
Align the draft arm with the
opening in the top of the unit,
then place inside and twist until
secure. No screws are necessary,
it locks into place simply. The thin
black gasket is not mandatory for
assembly.
Installing the Guardrail
Follow these steps below to install the guardrail.
1.
Place the guardrail on top of the cabinet.
2.
Align all holes of the guardrail with the holes
of the cabinet.
3.
Secure the guardrail to the cabinet by
placing inside corresponding rubber
holes.
Beer
Dispenser
Tower
Beer Duct
Guard Rail
Handle
Beer
Dispenser
Tower
Beer Line
Keg
Coupler
High-Pressure Valve
CO² Bottle
Shut Off Safely
CO² Line
Single-Gauge
CO² Regulator
Low Pressure
Valve
CO² Tank
Beer Keg
(Not Included)
13.5"
15.5"
15.5"
8.5"
24.75"
9"
23"
23"
