6
There are three different possible
backflow stoppers.
STEP 4
Connect the CO2
line from the
regulator to the
coupler.
STEP 1
High pressure washer installed into CO2
regulator (may already be installed).
STEP 2
Attach regulator to CO2 tank connector.
STEP 3
The CO2 rubber
directional
washer goes into
the coupler.
OR
STEP 5
Put one of the
backflow stoppers
in the coupler (the
torpedo goes in
with rounded side
down).
OR
Some units may
come with this
attachment. It
is not needed
and should be
removed from the
coupler prior to
STEP 3
.
Installing the CO2 Regulator and the CO2 Cylinder
Follow these steps to safely install the CO2 regulator and CO2 cylinder. You must read
and understand the following procedures for the CO2 cylinders before installation.
NOTE
: If all your rubber washers & O-rings are not pre-installed, please refer to your parts
list (pg. 6).
NOTE
: Your CO2 cylinder has DOT (USA Department of Transportation) approval,
however the cylinder has been shipped empty to avoid any possible accidents during
transportation. When you purchase the first keg of beer, you must also have your CO
2
cylinder filled at your local supplier. (see page 2, item 9 for suggested locations within your
community)
