E
N
G
LI
S
H
10
CO
2
& TAP TOWER INSTALLATION
You must read and understand the steps below for the CO2 assembly before installation.
When you purchase the first keg of beer, you must also have your CO2 cylinder filled at
your local supplier. CO2 tanks can be refilled at locations such as welding supply shops,
party stores, or wherever kegs are purchased.
(cont. on next page)
STEP 1
Make sure white nylon High Pressure
Washer (already installed) is attached
to CO2 Double Regulator.
STEP 2
Use Wrench to attach Double
Regulator to CO2 Tank connector.
STEP 3
Remove spring from inside the Keg Coupler.
If spring is not present, go on to
Step 4
.
STEP 4
Make sure Backflow Stopper is inserted
in the Keg Coupler (the Backflow Stopper
goes in with rounded side down).
STEP 5
After the Backflow Stopper has been
inserted, remove the three parts above.
Summary of Contents for KRS2100 SERIES
Page 2: ...KRS2100 SERIES Kegorator Instruction Manual Manuel d instruction Manual de instrucciones...
Page 3: ......
Page 49: ......
