ENGLISH
6
HOW TO OPERATE
1.
First, find a stable, waterproof surface near an electrical outlet before
starting. Make sure the cord is away from any water source.
2.
DO NOT place the RETRO SLUSH MACHINE near the edge of a table or countertop.
3.
Remove the Blending Chamber Lid by pinching the lock tab together
while lifting up on the Lid and carefully unhinging the front.
4.
Fill the Aluminum Cylinder with small or broken pieces of ice through
opening labeled ICE AND SALT, to within 1 inch of the Aluminum Cylinder
top. Ensure that the Spout is in the closed position to avoid spillage.
5.
Add ½ cup of regular table salt and ½ cup of water in the
Aluminum Cylinder (be sure to add salt first then water in order
to mix well). Salt is necessary for the freezing process. It may
take ½ cup of salt or more for your slush to freeze properly.
Return the Lid to Blending Chamber, making sure it is aligned
properly over the mixing mechanism, locked down securely
to the clear mixing chamber, and lid is latched securely.
6.
Slide the ON/OFF switch back to FREEZE to
turn the unit on and begin the slush making process. DO NOT turn the
unit OFF during use as the Aluminum Cylinder may freeze.
7.
Pour your selected beverage directly into the unit through the
molded square indention located on the top of your RETRO SLUSH
MACHINE. DO NOT fill beyond the MAX FILL line (approximately
1 qt. of liquid).
Sugar-free beverages and alcoholic beverages
will not freeze. DO NOT use them in the machine.
NOTE:
Do not use the slush maker to freeze liquids
without any sugar (such as water), as this may damage the
appliance. Water will freeze very quickly to the exterior
of the ice cylinder and could damage the unit.
8.
Allow the mixture to blend for up to 15 minutes until
you reach the desired slush consistency.
NOTE:
You can continually add ice and salt to the unit as you are creating slush by
dropping ice and salt into the round, open hole in the Lid above the Aluminum
Cylinder. DO NOT exceed filling the Aluminum Cylinder 1 inch from the top as
there is a risk that the slush mixture will become contaminated with salt.
9.
When mixture reaches desired consistency, place cup under Spout and slide the
ON/OFF switch forward to DISPENSE. Turn the slush
dispenser handle to the right to dispense drink. Keep
unit running until all slush has been dispensed. Be sure
to turn handle back to CLOSE after filling each cup.
NOTE:
If slush gets too thick, or does not dispense well,
add more liquid to the mixing chamber opening.
