Nothern Industrial tools 155305, Owner'S Manual

8

Installing the belt guard knob

1. To attach belt guard knob, locate knob and 5mm Dia. x 12mm long

pan screw in loose parts bag. Install screw in hole located on guard

and attach knob turning until tight.

WARNING! 

To avoid possible injury keep guard in place and in 

proper working order while operating.

Installing feed handles

1. Locate three (3) feed handles

among loose parts.

2. Screw the feed handles into

the threaded holes in the hub

and tighten.

Installing the chuck

1. Clean out the TAPERED HOLE in the chuck. Clean the tapered

surface on the arbor with a clean cloth. Make sure there are no

foreign particles sticking to the surfaces. The slightest piece of the

dirt on any of these surfaces will prevent the chuck from seating

properly. This will cause the drill to “wobble”.

2. Slide the chuck up over the arbor as illustrated.
3. Unlock support lock and raise table so its about two (2) inches below tip

of chuck.

4. Turn chuck sleeve clockwise and open jaws in chuck completely.
5. Turn feed handles counter-clockwise and force chuck against table until

chuck is secure.

Installing the light bulb

1. Install a light bulb (not larger than

60watt) into the socket inside the head.