ECN11-0061
1
1. Product Overview
IFS-2600 Termination Board (TB) is the main termination board, where connections from all other devices in the
panel and the field are terminated. The Power Supply Interface board (PSI) is mounted directly on top of the spacers
provided in the Termination Board which is available as a separate kit (#ASY-02-021). Both these boards are
mounted on a metal work chassis, which in turn is assembled in the IFS-2600 base panel. A power supply unit (PSU)
is mounted to the chassis, which powers the panel.
Figure 1, IFS-2600 Chassis
This is the IFS-2600 CHS chassis (#MW-02-012) onto which Termination board (#PCA-01-048) will be
assembled.
2. Installation
WARNING:
Installation should be performed by competent persons in accordance with the
relevant standards as required for the installation. Honeywell Ltd accepts absolutely no liability
for the suitability, settings or connections done within an installation.
1.
Attach the male end of four M3x20 M/F tapped spacers (#11164) to the four slots provided on termination
board and secure it using four M3 flanged nuts (#10313) as shown in Figure 2.
Figure 2, IFS-2600 Termination Board (NI-2025-01 PCB)
9 Columbia Way
Baulkham Hills, NSW 2153
PH 02-9894-1444 • FAX 02-9894-4193
Notifier IFS-2600 Termination Board (TB)
Product Installation Document
DOC-03-037
ECN11-0061
21/09/2011
Rev:
1.02
IFS-2600 Chassis
(#MW-02-012)
Studs to secure
Termination
Board
M3 Flanged Nuts (#10313)
to Male end of
Spacer (#11164)
