3
5.
6.
7.
8.
9.
10.
1 1.
12.
Lightly loosen the set screw, attach the fan body to the top of the
extension pole. Push the body down as far as possible and then tighten
securely with the set screw.
The motor shaft has the blade cap and guard nut attached. Remove the
cap by turning it clockwise and the nut by turning it anticlockwise.
Place the rear guard on the front of the motor housing, Make sure that the
handle is up the top. Push the guard in firmly until the three knobs protrude
through the holes. Secure the rear guard by reattaching the guard nut and
turning it clockwise to tighten.
If the motor shaft is covered with a protected sleeve, remove the sleeve.
Slide the blade onto the motor shaft, making sure to match the protrusions
on the shaft with the slots in the blade. Tighten the blade with the blade
cap, turning it anticlockwise to tighten it securely.
Test the fan by rotating the blade with your hands, making sure that there
is no contact with the nut. The fan blade should rotate freely.
The front and rear guard are held together with clips around the grill gaurd
trim. fix all the clips to make the grill guard well installed.
Your new Pedestal Fan is now fully assembled.
