Operating Your Heater
REMOTE CONTROL
If the appliance is new, or the batteries in the remote control are flat, 2 new AAA batteries must
be installed.
Slide off the battery compartment cover on the underside of the remote control.
Remove old batteries, if present
Insert new batteries, ensuring the correct polarity (+/-), as shown on the bottom of the battery
compartment.
Slide the battery compartment cover back into place.
The mains switch located at the top right hand side of the fire must first be switched on; the fire
will beep to indicate that it is powered up.
Once the main power switch is set to ON; the remote control performs all the same functions as
the main control panel.
It takes a little time for the receiver to respond to the transmitter. Do not press the buttons
more than once within two seconds for the fire to operate normally.
Press the ON/OFF button once to turn on the appliance and fire effect.
Press the 900W button once for the low heat setting; press twice to switch off the heat setting.
Press the 1800W button once for the high heat setting; press twice to switch off the heat
setting.
Press the DIMMER button to operate the dimmer mode, repeat pressing will raise and lower the
brightness.
