1. Unpacking
Thank you for choosing our LED blinder. For your own safety, please read this manual before
installing the device. This manual covers important information on installation and applications. Please
keep this manual for future reference.
This light uses 100-watt warm white led giving incredible output. Please unpack this fixture
carefully
and check whether it was damaged in shipping.
The following item should be in the box with the fixture:
1.Power wire 2. Signal wire 3. User Manual
2. Safety Instructions.
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning notes
written in this user manual. This fixture
is a high voltage fixture. Be careful when dealing with high
voltages.
Please read this manual. If you do not read this manual and damages occur to the fixture, then it
could void the warranty.
During shipping, the light may have been exposed to high temperature changes or humidity changes.
So, as a precaution, do not switch the light on immediately. Condensation can damage the fixture
so
leave
the fixture switched off until it has reached room temperature. The light
is an
INDOOR
operational fixture. Do
not
operate this fixture
outdoors
or anywhere there is high
humidity.
The electric connection must carry out by a qualified person and it is absolutely essential that
the
fixture be
grounded
. So, under no circumstances break off the ground pin on the Edison plug or use
the fixture where a ground is not present. A ground pin, like the fuse for the fixture
is there for safety.
Always disconnect the fixture from the power source, when the fixture is not in use or before cleaning
it. Only unplug it from the power source holding onto the Edison plug. Do
not
pull out the Edison plug
out by just pulling on the power cord itself.
Please keep the fixture away from children and the general public. Please be intelligent and use
common sense when operating the fixture.
3. General Guidelines.
This fixture
is a lighting fixture for professional use on stages, in clubs, concert etc.
This fixture should only be operated at between 90 to 240 volts and only indoors.
This fixture
should not be operated 24/7 (24 hours a day; 7 days a week). This fixture
needs operation
breaks to ensure that it will work for a long time without problems. Please do not shake the fixture
and
avoid using brute force when installing or operating it.
When choosing the location to install the fixture, please make sure that it is not exposed to extreme
heat, moisture or dust and never install it
outdoors
. Make sure that the fixture has a good amount of
free space around it for air flow. Do not install it in a confined space or have insulation around the
fixture. The minimum distance between the fixture
and the illuminated surface must be more than 3
feet.
Always mount the fixture
with an appropriate safety cable.
