10
INSTALLING AND REMOVING
THE BATTERY
Always switch off the hammer drill
before insertion or removal of the
battery.
INSTALLING THE BATTERY
1. Hold the hammer drill upright and pick
up the battery in your opposite hand.
Place two fingers over the battery release
buttons and insert the battery until it
clicks into place (Fig. 1).
2. Do not use excessive force when
inserting the battery. If the battery does
not slide in easily, it is not being inserted
correctly. It is also possible that there
could be damage to the battery, battery
terminals or the drill.
REMOVING THE BATTERY
Press both the battery release buttons on
either side and gently pull the battery out
of the drill.
BATTERY LIFE
The length of service from each charging
cycle will depend on the type of work you
are doing. To obtain the longest possible
battery life, we suggest the following:
› Store and charge your battery in a cool
area. Temperatures above or below normal
room temperature will shorten battery life.
› Never store batteries in a uncharged
condition. Recharge them immediately
after they are uncharged.
Fig.1
Summary of Contents for NG-58
Page 17: ...17...
Page 18: ...18 NOTES...
Page 19: ...19...
Page 20: ...Spot on Laser and Tool Company 1300 658 338 www spoton com au...