11
› All batteries gradually lose their
charge. The higher the temperature
the quicker they lose their charge. If
you store your drill for long periods
of time without using it, recharge the
batteries every month or two. This
practice will prolong battery life.
ASSEMBLY
INSTALLING DRILL BITS
NOTE:
Only use accessories with SDS
or SDS Plus shanks.
Be sure that the shank of the bit is
clean. Dirt particles may cause the bit
to line up improperly. To avoid gear
damage or motor overloading do not
use bits larger than the maximum
recommended capacity of the drill. For
best performance, be sure that the bit
is properly sharpened and the shank is
lightly greased before use.
1. Remove the battery from the drill.
2. Pull the releasing collar inwards
(Fig. 2) and insert the bit. Release the
collar so the bit holds in place (Fig. 3).
3. Pull on the bit to ensure it is inserted
correctly.
Fig.2
Fig.3
*Bit not included
Summary of Contents for NG-58
Page 17: ...17...
Page 18: ...18 NOTES...
Page 19: ...19...
Page 20: ...Spot on Laser and Tool Company 1300 658 338 www spoton com au...
