6
Children should be supervised
to
ensure that they don’t play with the
appliance.
Recommendations for the use of a
residual current device
with a rated
residual current of 30mA or less:
› Wear a hard hat (safety helmet),
safety glasses and/or face shield. It
is also highly recommended that you
wear a dust mask, ear protection and
padded gloves.
› Secure the work piece. A work piece
clamped with clamping devices or
in a vice, is held more secure than
by hand.
› One-handed operation can be
hazardous. It is recommended you
hold the unit firmly with both hands
when operating the tool.
› After installing the drill bit, pull
lightly on the bit to make sure that it
does not come loose. If the bit is not
installed properly, it can come loose
during use, which can be dangerous.
› Use a bit that is appropriate for the
application.
› Hold the power tool with a firm grip.
High reaction torque can briefly occur.
› Check that any bit to be used is not
cracked or broken. Broken or cracked
bits are dangerous.
› If the ring securing the bit is
damaged, the socket may come off
during use causing personal injury.
› The torque delivered by the hammer
drill depends on how long it is
applied, the size of bit and other
ADDITIONAL SAFETY RULES
FOR HAMMER DRILL
a) Wear ear protectors.
Exposure to
noise can cause hearing loss.
b) Use auxiliary handle(s), if
supplied with the tool.
Loss of
control can cause personal injury.
c) Hold power tool by insulated
gripping surfaces, when performing
an operation where the cutting
accessory may contact hidden
wiring.
Cutting accessory contacting
a “live” wire may make exposed metal
parts of the power tool “live” and
could give the operator an electric
shock.
This appliance is not intended for
use by persons (including children)
with reduced physical, sensory
or mental capabilities, or lack of
experience and knowledge,
unless
they have been given supervision or
instruction concerning use of the
appliance by a person responsible for
their safety.
a qualified repair person using only
identical replacement parts.
This will
ensure that the safety of the power
tool is maintained.
b) If the supply cord is damaged,
it must be replaced by the
manufacturer,
its service agent or
similarly qualified persons in order to
avoid a hazard.
Summary of Contents for NG-58
Page 17: ...17...
Page 18: ...18 NOTES...
Page 19: ...19...
Page 20: ...Spot on Laser and Tool Company 1300 658 338 www spoton com au...