30
3.
Insert the condensate hose (4) into the drain
opening and screw it ti ght (2); then fasten with the
hook.
4.
Insert the cap at the other end of the hose (1) for
the condensate drain, att ach with the hook (2) and
then insert into the clamp (5).
COOLING
In the case of cooling operati on, make sure that the rubber seal that closes the
drain opening on the back is correctly positi oned.
To empty the container, the air conditi oner must be switched off and the mains
plug pulled out. Remove the lid from the rear drain opening and positi on the
end over a normal water drain.
You need to make sure that the hose is not twisted and bent. The hose must
have a slope. Close the drain opening with a lid, insert it into the clamp and put
the air conditi oning back into operati on.
DEHUMIDIFY
WARNING!
When using the air conditi oner in dehumidifi cati on mode, it is always advisable to connect the conti nuous drain to ensure
maximum dehumidifi cati on effi ciency.
Use the drain opening in the middle. The water can be drained into a drain (not included) by simply connecti ng a 14mm
inner diameter hose.
1. Remove the lid (turn counterclock-
wise), then remove the cap.
4. Avoid curves on the drainage hose.
2. Screw the connecti ng pipe (inclu-
ded in delivery) clockwise.
3. Then insert the drain hose into the
pipe connecti on.
1
2
3
5
4
