novaG-A
Manual Service
15/25
1.2 Issue
Ref. NR-00016-ENG
10.
To clean the product holes of the chamber, use suitable brushes of the right size for the
holes. It is not necessary to remove the head chamber to do this operation.
Cleaning “Round” Chamber Product Input
Holes
Cleaning “Round” Chamber Product
Output Hole
N.B.: the chamber cleaning chucks are attached with them in the spare parts and in the
gun tool kit.
11.
Put the block in a vessel with gun cleaning liquid.
12.
To eliminate all product remains, put the gun block unit in a vessel with gun cleaning liquid
and rub it with a brass brush.
PRECAUTION:
Use wooden or plastic utensils or a brass brush for cleaning. Do not
use metal utensils that can scratch the contact surfaces.
Rearm the gun according to the following procedure:
13.
Screw on the friction bushing cartridges by hand, paying attention to the location of each
one (“A” ISO side and “R” POL side).
