novaG-A
Manual Service
20/25
1.2 Issue
Ref. NR-00016-ENG
9.
Make sure the trigger shaft housing is clean and apply a small layer of grease inside.
10.
Fit the air hose to the rear of the gun with sealing paste on the thread to avoid air leaks.
11.
Insert the trigger shaft in the spring and insert it inside the grip taking special care not to
damage the o-rings. You will note a certain resistance caused by the interference of the
seals with the housing wall.
12.
Screw on the trigger valve nut until it comes up against the base.
13.
Fit the trigger with the screw and hold it with the retention nut.
14.
Fit the trigger stop screw. Screw it to eliminate the play in the trigger (without moving the
shaft).
15.
Fix the mixing block according to the procedure described in the pistol block unit and mix
chamber assembly section.
16.
Start the gun.
