novaG-A
Manual Service
22/25
1.2 Issue
Ref. NR-00016-ENG
10.
Fit the cylinder block on the blocking screw. Slip the spring and the blocking device on the
blocking screw. Screw in the two adjustment screws, making sure that they are perfectly
flush with the flats at the end of the blocking screw. Make sure that the blocking device is
well-fitted.
11.
Insert the spring in the rear housing of the plunger. Insert the cylinder block unit in the
lining, pressing until it passes the insertion groove of the retention ring.
12.
Fit the retention ring, using pliers for seeger rings.
WARNING:
To guarantee that the
cylinder block is correctly fixed, make
sure that the retention ring is perfectly
housed in the fixing groove. To avoid any
possible
error
in
assembly,
avoid
approaching the cylinder block when
pressure is applied to the gun after
performing any cleaning, repair or
maintenance work.
13.
Fit the sleeve staple and fix it with the
screw to the rear of the gun.
14.
Start the gun.
