NOVAK DATA LOGGER, Instruction Manual

Novak Electronics, Inc.

 | 

Configure Device

2

2

2

2

www.teamnovak.com

Shown are default Values



Enduro Mode

– This feature allows the recording of multiple battery packs all 

in one reading.  By selecting this option, the Maximum Number of Runs will be 
set to one, and all of the data will be stored in one log file for review.



Remote Start/Stop

– By selecting this option, you can remote start/stop data 

acquisition from your transmitter by either applying full brake or full steering in 
one direction for the allotted amount of time. 



Remote Start/Stop

 Activation After

– The time, in seconds, the 

throttle/steering needs to be applied before activating remote start/stop.



Calibrate Button 

– Calibrates the throttle/steering position for remote start 

and input signal data display.

CUSTOMIZE INPUT SIGNAL

Calibrate the throttle/steering position for remote start and input signal data display. 

WARNING!

  Before starting to calibrate the input signal, please make sure the motor wires or motor sensor 

harness is disconnected from the speed control.  This will prevent motor damage.

1.

Make sure the correct throttle/steering input harness is plugged into the Novak 
Sentry.  Turn on the transmitter and ESC. When you finish this step, click the 

OK

button to continue.

2.

Pull the throttle to full throttle, or turn steering all the way to the right.  Click the 

OK

button when the transmitter is in this position.

3.

Pull the throttle to full brake, or turn steering all the way to the left.  Click the 

OK

button when the transmitter is in this position.

4.

Make sure the throttle/steering is in the neutral position.  Click the 

OK 

button when 

the transmitter is in the neutral position.

5.

Choose a position between neutral and full brake/steering. This is the remote 
start/stop activation position.  The system will automatically start/stop recording 
when the throttle/steering goes beyond this position for the configured amount of 
time.  Click the 

OK

 button when the transmitter is in the remote start/stop 

activation position.

6.

At this point, the remote start calibration is complete.  You must click on the 

OK

button on the 

Device Settings

 dialog box in order to save the calibration setting.

NOTE

If at any time the transmitter settings change, you may have to recalibrate.