Chapter 6 Ethernet Configuration
CPT7 and CPT7700 Installation and Operation User Manual v12
117
6.3 Dynamic IP Address Configuration
Figure 37: Dynamic IP Address Configuration through a DHCP Server—OEM7 Receiver
below shows the
connections when an OEM7 receiver uses a dynamic IP address configuration.
Figure 37: Dynamic IP Address Configuration through a DHCP Server—OEM7 Receiver
To set up a dynamic IP address configuration, follow these steps:
1. Connect a computer to the OEM7 receiver using a null modem serial cable or USB cable (model
dependent).
2. Establish a connection to the receiver using either NovAtel Application Suite or another terminal program.
This connection is used to send the commands in this procedure to the receiver.
For information about using NovAtel Application Suite, refer to
3. Enable the Ethernet port by entering:
ETHCONFIG ETHA AUTO AUTO AUTO AUTO
4. Obtain the IP address assigned to the OEM7 receiver by the DHCP server.
LOG IPSTATUS ONCE
Make a note of the IP address returned with this log.
5. Assign the TCP/IP port number by entering:
ICOMCONFIG ICOM1 TCP :2000
