Chapter 11 NovAtel Firmware
CPT7 and CPT7700 Installation and Operation User Manual v12
156
guaranteed to be output from the receiver within 300 seconds from the time the
SOFTLOADCOMMIT
command was received by the receiver.
7. Send the auth code for the newly downloaded image using the
AUTH
command. This is only required if
there is not already a signature auth code on the receiver as signature auth codes are maintained through
a SoftLoad update. See
on page 141 for details on Auth Codes.
AUTH ADD_DOWNLOAD <AUTH CODE>
8. Reset the receiver using any of the following methods:
l
Enter the
RESET
command
l
Enter the
FRESET
command
l
Power-cycle the receiver
Once the receiver resets, the new version of firmware is active.
The SoftLoad process can be safely canceled at any time using the
SOFTLOADRESET
command or by
otherwise resetting the receiver. Once the COMPLETE status is reported by SOFTLOADSTATUS, the new
firmware image will be run after the receiver is reset.
