Chapter 6 Ethernet Configuration
CPT7 and CPT7700 Installation and Operation User Manual v12
118
6. Confirm the port number assigned to ICOM1 by entering:
LOG ICOMCONFIG ONCE
6.4 Base/Rover Configuration through Ethernet Connectivity
You can use an Ethernet connection to provide communication between a base and rover receiver.
Figure 38: Base/Rover Ethernet Setup—OEM7 Receiver
below shows the connections when a base and
rover OEM7 receiver are connected using Ethernet.
Figure 38: Base/Rover Ethernet Setup—OEM7 Receiver
1. Connect your computer to both OEM7 receivers using null modem serial cables or USB cables.
2. Establish a connection to the receiver using either NovAtel Application Suite or another terminal program.
This connection is used to send the commands in this procedure to the receivers.
For information about using NovAtel Application Suite, refer to
3. Connect the power cables to both of the OEM7 receivers and apply power to the receivers.
4. Connect the Ethernet cables to the Ethernet ports on both OEM7 receivers.
5. Establish an Ethernet connection, either static or dynamic configurations. Refer to
on page 114 or
Dynamic IP Address Configuration
on the previous page for more
information.
