Chapter 10 Troubleshooting
CPT7 and CPT7700 Installation and Operation User Manual v12
137
Bit Set
Action to Resolve
28
Digital filter status. When this bit is set to 1, an Interference Toolkit digital filter is enabled.
29
None. This bit indicates if any bits in the auxiliary 3 status word are set. The auxiliary 3 word provides
status information and does not contain any new information on problems. Refer also to the
FRESET
command.
30
None. This bit indicates if any bits in the auxiliary 2 status word are set. The auxiliary 2 word provides
status information and does not contain any new information on problems. Refer also to the
FRESET
command.
31
None. This bit indicates if any bits in the auxiliary 1 status word are set. The auxiliary 1 word provides
status information and does not contain any new information on problems. Refer also to the
FRESET
command.
For information about the commands and logs in this section, refer to the
10.2 Examining the AUX1 Status Word
Table 24: Resolving an Error in the AUX1 Status Word
below provides actions to take when your receiver has
an error flag in the AUX1 status word.
Bit Set
Action to Resolve
0-2
Jammer detected
3
None. This bit indicates that Position Averaging is ON
4-6
Jammer detected
7
Connect the receiver via USB
8-10
Reduce the amount of logging on the USB ports
11
(Reserved bit)
12
None. This bit indicates a Profile set using the
PROFILE
command is activated.
13
Throttled Ethernet Reception
Check for unusually high Ethernet traffic being directed to the Receiver.
This does not represent an error condition on the receiver, but suggests there may be an issue in the
network environment on the receiver.
14-17
AGC error on RF1 through RF4 respectively. To resolve, ensure the antenna cable is connected and
signal input level is within specification. Contact NovAtel
on page 16 for additional
information.
18
Connect the receiver via Ethernet.
See
Table 24: Resolving an Error in the AUX1 Status Word
