19
novatelwireless.com
Installing The Power Cable
Connect the power cable to the device before mounting the device.
Connect a 12V or 24V vehicle ready power supply to the device. Pin-5 of the Molex connector.
The voltage must be within the 9 - 32 VDC range. See
"Technical Specifications" on page 8
Connect the device (Pin-4) to the vehicle ground.
Mounting The Device
Mounting Bracket
To mount the device using the Mounting Bracket, use the accessory SKU # 21915042
While performing these steps, do not apply excessive force to the retention legs or snap
feature prior to inserting the device as this may deform the mounting bracket.
Figure 2-8 SA 2100 Mounting Bracket
1. Secure the mounting bracket to the desired mounting surface using one of the following
methods:
l
Two (2) # 6 screws
l
Double-sided tape
2. Insert the device into the mounting bracket as shown in the figure above. The device
should be inserted with the battery compartment down. Take care to position the
device so that the top of the device has the best unobstructed path to the sky.