SPAN-SE Installation
Chapter 2
SPAN-SE User Manual Rev 1
33
For advanced users
: If you have additional equipment to connect to your system requiring an
output timing pulse, or an input pulse into SPAN-SE, see
Section 3.10, Synchronizing External
Section A.1.1.3, I/O 2 Yellow Cable (NovAtel part number
for its bare wire pin-outs. The jacket insulation is cut away slightly
from the end but the insulation on each wire is intact. Then, refer to your device’s
documentation for information on its connectors and cables. The arrow along the cable in the
figure indicates a MARKIN pulse from the user device on the right to the SPAN-SE I/O port.
+
-
Voltage
Supply
