236
SPAN-SE User Manual Rev 1
Appendix C
Data Logs
C.4.39 MARK1TIME, MARK2TIME, MARK3TIME, MARK4TIME
Time of
Mark Input Event
This log contains the time of the leading edge of the detected mark input pulse. MARK1TIME gives
the time when a pulse occurs on the MK1I input, MARK2POS is generated when a pulse occurs on a
MK2I input and so on.
These logs allow you to measure the time when events are occurring in other devices (such as a video
recorder). See also the SETMARK
x
OFFSET commands starting on
.
1. Use the ONNEW trigger with this or the MARK
x
PVA logs.
2. Only the MARK
x
PVA logs, the MARK
x
TIME logs, and ‘polled’ log types are generated ‘on
the fly’ at the exact time of the mark. Synchronous and asynchronous logs output the most
recently available data.
MARK1TIME Message ID: 1130
MARK2TIME Message ID: 616
MARK3TIME Message ID: 1075
MARK4TIME Message ID: 1076
Log Type: Asynch
Recommended Input:
log mark1timea onnew
Example:
#MARK1TIMEA,COM1,0,98.0,FINESTEERING,1521,336487.000,00000000,0000,149;1521,3
36487.000000025,0.000000000,0.000000000,-14.999999992,VALID*7597ecee
#MARK2TIMEA,COM1,0,98.5,FINESTEERING,1521,336487.000,00000000,0000,149;1521,3
36487.000000025,0.000000000,0.000000000,-14.999999992,VALID*8fd08ef6
#MARK3TIMEA,COM1,0,98.5,FINESTEERING,1521,336487.000,00000000,0000,149;1521,3
36487.000000025,0.000000000,0.000000000,-14.999999992,VALID*ed342f79
Table 54: Clock Model Status
Clock Status
(Binary)
Clock Status
(ASCII)
Description
0
VALID
The clock model is valid
1
CONVERGING
The clock model is near validity
2
ITERATING
The clock model is iterating towards validity
3
INVALID
The clock model is not valid
4
ERROR
Clock model error
