Technical Specifications
Appendix A
SPAN-SE User Manual Rev 1
77
A.2.2.1
iIMU-FSAS Interface Cable
The NovAtel part number for the 1 m iIMU-FSAS interface cable is 01018221
(see
Figure 29, iIMU-FSAS Interface Cable
if applicable.
To talk to the SPAN-SE with the iIMU-FSAS interface cable, a FSAS SPAN-SE Y Adapter cable is
needed. Please see
for cable pin-out information.
The iIMU interface cable supplied, provides power to the IMU from an external power source, and
enables input and output between the receiver and IMU.
below shows the iIMU interface
cable connections when used with a SPAN-SE receiver while the rest of the SPAN-SE connections are
Figure 25: iIMU Interface Cable Connections with a SPAN-SE
Reference
Description
1
SPAN-SE receiver
2
iIMU-FSAS IMU
3
I/O 2 yellow cable’s 30-pin connector to I/O 2 port on the SPAN-SE
4
iIMU interface cable’s DB-9 IMU connector to iIMU interface Y cable
5
iIMU interface cable’s DB-9 I/O connector to iIMU interface Y cable
6
iIMU interface Y cable to I/O 2 yellow cable’s DB-9 IMU connector
7
iIMU interface cable’s DB-9 ODO connector to (optional) wheel
sensor cable
8
iIMU interface cable’s (+ve) and (-ve) connectors to user-supplied
power source
9
iIMU interface cable’s MIL 22-pin connector to the iIMU-FSAS IMU
iMAR FSAS
LN-200 or HG-1700
IMU
I/O
1
2
3
7
9
8
4
5
6
