86
English
SYSTEM SETTINGS
Global settings for Circuit Mono Station are made using
System Settings View
. This lets you
configure MIDI operation and set MIDI channels, enable Pot Pickup and set the analogue clock
output rate.
System Settings View
can only be opened at power-up: press hold
Shift
15
down while pressing
the
Power
button to open the View. The View changes (re colours) according to whether
Oscillator 1 or Oscillator 2 is selected: the graphic below shows that for Osc 1.
MIDI Note data
MIDI CC data
External clock control
Bright pad indicates
currently selected
MIDI channel for
Osc 1
Dim red pad indicates unavailble
MIDI channel
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
MIDI Channel Selection
Analogue clock PPQN settings
MIDI Note
RX
On/Off
MIDI CC
RX
On/Off
MIDI CC
TX
On/Off
RX
On/Off
TX
On/Off
Pot pickup
On/Off
MIDI Note
TX
On/Off
System Settings View
is exited by pressing the
(Play) button.
MIDI I/O
You can choose to transmit and/or receive MIDI Note data, MIDI CC (Control Change) data and
MIDI clock independently. When Circuit Mono Station is shipped from the factory, it is set to
transmit AND receive all three classes of MIDI information. This flexibility allows you to integrate
Circuit Mono Station with other hardware in exactly the way you need.
Circuit Mono Station is able to send and receive MIDI data both via the USB port
8
and the
dedicated MIDI IN and MIDI OUT sockets
3
. Use the 3.5 mm TRS jack-to-5-pin DIN breakout
cables supplied to use standard MIDI cables to connect the latter to other MIDI equipment.
MIDI Tx/Rx
The first two pads in the bottom row are illuminated green and control MIDI Note data Rx
and MIDI Note data Tx respectively. A dim illumination means that Tx or Rx is OFF; a bright
illumination indicates that Tx or Rx is ON.
The transmission and/or reception of MIDI CC data can be controlled in exactly the same way
by the next two pads, coloured Orange.
Summary of Contents for Circuit Mono Station
Page 1: ......
Page 93: ...93 English...