USING THE FACTORY INSTALLED TEMPLATES
A set of 7 pre-printed and 3 blank template overlays are supplied with the Remote LE. The following notes detail
which physical overlay to use with each one of the 12 factory installed template memories and how to use the
resource files located on the supplied CD.
Template 1 - NOVATION - V Station
Use the VA Synth template label. The template is programmed to control version 1.4 or higher of the plug-In.
If you have an earlier version, go to www.novationmusic.com to download the latest version.
Template 2 - NOVATION - Bass Station
Use the VA Synth template label.
Propellerheads Reason Instruments.
The Transport bar of the Reason Sequencer will respond in both Templates once the ‘Learn’ procedure detailed
in the Sequencer Template Setup section of this addendum has been carried out.
Two instruments have been provided as factory presets ;
Template 3 - REASON - Subtractor
Use the Subtractor template label.
Template 4 REASON - Malstrom
Use the Malstrom template label.
Template 5 NATIVE INSTRUMENTS - FM7
Use the FM7 template label.
The FM7 does not have specific control numbers for parameters. There is an FM7 setup file
‘REMOTE_LE.F7c’
on the resources CD, which must be loaded into the FM7.
To load the file into the FM7, click on the controller ‘LOAD’ button in the master section of the FM7. Navigate to
the file ‘REMOTE_LE.f7c and open it. Note this can then be saved to the c:/program files/native
instruments/FM7/assigns folder where C: is the hard drive that the FM7 is installed on. From the FM7
preferences option, make sure that the following options are checked:
1
MIDI controller range 000-127
2
0...63: off 64...127: on
3
Use OP A controllers for selected op
4
OP Select controller: 9
5
Use 3 ccs for ratio.
