3 USING THE 2D SOFTWARE
The 2D application is named as “Vision”. When using the 2D system the height reference can be
taken from laser reference (optional laser received is needed) or a stake (any physical height
reference can be used). System can measure height and distance. Height reference have to be
taken again when machine is relocated.
3.1 Getting started
When the Vision is started the Main menu is shown as in Fig. 8 below. To starting work with 2D,
press “Start” button 1.
Selections
from the Main menu of the Vision
(fig 8)
:
(1)
Start
opens “2D work view”
as seen in the
fig. 7
◦
“Measurement / work view”
(2)
Language
opens language selection
◦
Language of 2D software user interface can be changed
.
(3)
Settings
opens 2D software settings
◦
For example, bucket calibration (measurements and plumbline calibration)
3.2 Measurement / work view
The fig. 7 displays software's measurement / work view. It can be used, for example, to measure
depth, distance and slope. Operator can see measurements results and change view angles.
To begin work select
Main menu → “Start”
User Manual. Xsite PRO SPI 14.2 Page 13 / 77
Fig.
8. Main menu of Vision
Fig.
7
.
Measurement / work view
Summary of Contents for XSITE PRO SPI 14.2
Page 1: ...XSITE PRO SPI 14 2 USER MANUAL Version 1 14 2 46 October 2018...
Page 33: ...Fig 36 Tilt bucket calibration User Manual Xsite PRO SPI 14 2 Page 30 77...
Page 76: ...User Manual Xsite PRO SPI 14 2 Page 73 77...
Page 77: ...User Manual Xsite PRO SPI 14 2 Page 74 77...
