Page 6
On the top of the solenoid
,
connect the RED 6 ga. wire to the terminal C
.
Route the opposite end of the RED 6 ga. wire to the circuit breaker
and connect the RED
6 ga. wire to the unmarked side of the circuit breaker
. (
see Fig. 6)
Step ( 2 )
Step ( 3 )
On the top of the solenoid
,
connect the BLACK 6 ga. wire to terminal
D
. (
see Fig. 3
)
On the solenoid
,
check that the short BLACK jumper wire lead, is installed from the
solenoid
’
s center
at spade connector
E
,
to the solenoid
’
s terminal
D
. (see Fig. 3).
Step ( 4 )
Step ( 5 )
Attach the BLACK wire from the rocker switch to the outer right spade,G connector, of the
solenoid.Attach the BLACK wire from the optional socket assembly to the same outer
right pade connector,G note;the solenoid top side up(see Fig.6 and 3)
Step ( 6 )
Attach the GREEN wire from the rocker switch to the outer left spade connector G on the
solenoid.Attach the GREEN wire from the optional socket assembly to the same outer
left spade connector G.note;the solenoid top side up(see Fig.6 and 3)
Step ( 7 )
Connect the RED WIRE, from the rocker switch and optionally from the socket assembly
to your ATV’s Ignition Switch key controlled wire. This wire must only have power when
the key is in the on position. A fuse protected key controlled wire is preferred. Fuse
should be rated for at least 4 amps. Cover-wind the connection with muti-layers of CE
approved electrical insulation tape, (see Fig. 6).
Connect the short RED 6 ga. wire to the end of the circuit breaker, marked positive.
Connect the other end of this RED wire to the “+” positive battery terminal. (see Fig. 6)
Step ( 8 )
Route the opposite end of the BLACK wire from, solenoid terminal D, and connect to the
“-” negative terminal on the battery. (see Fig. 6)
Step ( 9 )
Step ( 10 )
Check that all wiring is clear of sharp edges and pinch points. Check that all wiring is
firmly connected to it’s proper terminal or spade connector. Secure loose wiring with tie
wraps and electrical insulation tape.
1
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
2
21
23
24
26
27
28
29
30
31
22
25
35
36
37
34 33
32
44
41
38
39
42
43
45
46
40
47
Explosion Drawing with
4500WR
Page 35
Summary of Contents for FENIX 25
Page 2: ......
