From the AppArmor Configuration screen, determine whether Novell AppArmor and
security event notification are running by looking for a status message that reads enabled
or configure the mode of individual profiles.
To change the status of Novell AppArmor, continue as described in
Section 3.6.1,
“Changing Novell AppArmor Status”
(page 46). To change the mode of individual
profiles, continue as described in
Section 3.6.2, “Changing the Mode of Individual
Profiles”
(page 47). To configure security event notification, continue as described in
Section 6.2, “Configuring Security Event Notification”
(page 88).
3.6.1 Changing Novell AppArmor Status
When you change the status of AppArmor, set it to enabled or disabled. When AppArmor
is enabled, it is installed, running, and enforcing the AppArmor security policies.
1
Start YaST and select Novell AppArmor > AppArmor Control Panel.
2
Enable AppArmor by checking Enable AppArmor or disable AppArmor by des-
electing it.
3
Click Done in the AppArmor Configuration window.
46
Novell AppArmor Administration Guide
