56
SLES 10 Storage Administration Guide
no
vd
ocx
(e
n)
6 Ap
ril 20
07
Feb 14 01:03 multipathd: mpath4: event checker started
Feb 14 01:03 multipathd: mpath5: event checker started
Feb 14 01:03:multipathd: mpath4: remaining active paths: 1
Feb 14 01:03 multipathd: mpath5: remaining active paths: 1
5
Repeat
Step 2
through
Step 4
to add paths through other HBA adapters on the Linux system
that are connected to the new device.
6
Run the Multipath tool to recognize the devices for DM-MPIO configuration. At a terminal
console prompt, enter
multipath
You can now configure the new device for multipathing.
5.15 Managing I/O in Error Situations
You might need to configure multipathing to queue I/O if all paths fail concurrently. In certain
scenarios, where the driver, the HBA, or the fabric experiences spurious errors, it is advisable that
DM-MPIO be configured to queue all I/O where those errors lead to a loss of all paths, and never
propagate errors upwards. Because this will lead to I/O being queued indefinitely unless a path is
reinstated, make sure that
multipathd
is running and works for your scenario. Otherwise, I/O
might be stalled forever on the affected multipathed device, until reboot or until you manually return
to failover instead of queuing.
To test the scenario:
1
In a terminal console, log in as the
root
user.
2
Activate queuing instead of failover for the device I/O by entering (all on the same line):
dmsetup message 3600601607cf30e00184589a37a31d911 0
queue_if_no_path
Replace the UUID (
3600601607cf30e00184589a37a31d911
) with the UUID for your
device.
3
Return to failover for the device I/O by entering (all on the same line):
dmsetup message 3600601607cf30e00184589a37a31d911 0
fail_if_no_path
Replace the UUID (
3600601607cf30e00184589a37a31d911
) with the UUID for your
device.
This command immediately causes all queued I/O to fail.
To set up queuing I/O for scenarios where all paths fail:
1
In a terminal console, log in as the
root
user.
2
Open the
/etc/multipath.conf
file in a text editor.
3
Uncomment the defaults section and its ending bracket, then add the
default_features
setting, as follows:
defaults {
default_features "1 queue_if_no_path"
}
4
When you are ready to return over to failover for the device I/O, enter (all on the same line):
dmsetup message
mapname
0 fail_if_no_path
Summary of Contents for LINUX ENTERPRISE SERVER 10 - STORAGE ADMINISTRATION GUIDE 7-2007
