Documentation Updates
253
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
E.20 May 2, 2008
Updates were made to the following sections. The changes are explained below.
Section E.20.1, “Installation and Setup,” on page 253
Section E.20.2, “Managing Novell Cluster Services,” on page 253
E.20.1 Installation and Setup
E.20.2 Managing Novell Cluster Services
Location
Change
Section 3.5.1, “Installing
Novell Cluster Services
during a OES 2 Linux
Installation,” on page 42
A one-node cluster can be configured without an SBD (split-brain
detector). However, for adding a second node in the existing cluster
(without SBD), you need additional pre-configuration of creating the SBD
partition on the shared disk by using
sbdutil
on the first node.
Section 3.5.2, “Installing
Novell Cluster Services on
an Existing OES 2 Linux
Server,” on page 44
Corrected the procedure to use the YaST Control Center. You cannot
install Novell Cluster Services by going directly to the
yast2 ncs
option
at the command line.
A one-node cluster can be configured without an SBD (split-brain
detector). However, for adding a second node in the existing cluster
(without SBD), you need additional pre-configuration of creating the SBD
partition on the shared disk by using
sbdutil
on the first node.
“Configuring an Unload
Script for a Linux POSIX
Volume Cluster Resource”
on page 165
In OES 2, use
deactivate_evms_container
instead of
deport_evms_container
.
Location
Change
Section 8.2, “Monitoring
Cluster and Resource
States,” on page 99
When the resource is in Start Alert state, you must clear the alert before
you can offline the resource. After the resource is offline, you can online
the resource.
Section 8.15, “Deleting a
Cluster Node from a Cluster,
or Reconfiguring a Cluster
Node,” on page 109
Details have been added for clarification.
Section 8.13, “Moving a
Cluster, or Changing IP
Addresses, LDAP Server, or
Administrator Credentials for
a Cluster,” on page 105
This section is new.
