12
Noventri Eco-Series User Guide
SF-100E-0160-01 REV 03
5.9
Now that the SF-100e is setup correctly it will be able to communicate with your
Noventri Server™
software.
6. Stand-Alone Usage (Sneakernet)
6.1
When using the SF-100e as a stand-alone (Sneakernet) Player, the
Server™
software
is not needed.
6.2
Use the
Suite™
software to create a Project with sequences of images that you want
to publish to the SF-100e. (See the
Noventri Suite™ Design User Guide
)
6.3
Insert the USB Thumb Drive that came with your SF-100e into the USB port on the
computer where the
Suite™
software
was installed.
6.4
Going to
Publish > Publish to Thumb Drive
will save the Project you created onto
the USB Drive.
6.5
After powering up your SF-100e, safely remove the USB Drive from the computer and
plug it into the USB port of the SF-100e.
6.6
The SF-100e will read the files on the USB Drive and automatically start playing the
Project with sequences of images displayed on the monitor.
Note:
If the SF-100e requires a firmware update, publishing using Sneakernet will
automatically update the player first before the Project begins to play.
7. Factory Defaults
7.1
If you need to reset your settings to Factory Defaults, you can do this by clicking the
DEFAULT
button when you are logged into the
Noventri SF-100e CONFIGURATION
.
If you are having trouble connecting to the player or have forgotten your password, the
SF-100e has Factory Defaults that can be restored by pressing the
Reset
switch
located on the SF-100e.
7.1.1 The
Factory Default
will reset the following to:
•
DHCP
– ENABLE (without DHCP, will use the settings below)
•
IP ADDRESS
–192.168.0.190
•
NETMASK
– 255.255.255.0
•
GATEWAY
– 192.168.0.1
•
DNS 1
– 192.168.0.1
•
DNS 2
– 0.0.0.0
•
NOVENTRI SERVER
– [Not Reset]
•
PASSWORD
–
noventri