Operating Manual
LA-BO
2.
Dispense a single label on the vacuum grid of the applicator. The label should not touch any of the
knobs on the adjusting bars.
The label is not dispensed straight on the grid or still sticks with the trailing edge on the dis-
penser?
► Check the height adjustment of the dispenser in relation to the vacuum grid.
3.
Carefully adjust the bars to the label size by moving the knobs just against the label edge, without
touching the edge of the label. Bars outside the width of the label should be fully moved inwards
the vacuum grid so all the air nozzles above this bar are closed.
4.
Proceed some dispensing tests and check if the knobs on the bars are not touching or holding the
edge of the dispensed label.
Results
Fig. 14: Adjusting the bars in the vacuum grid so air nozzles outside the label surface are closed off.
In most applications with a blow-on applicator, it will be difficult to visually verify the position of the
sliding bars from the bottom side of the vacuum grid. Therefore, the bars can also be adjusted by
matching the section of the bars outside the vacuum grid to the label surface, as shown on the fig-
ure below:
Edition 05 - 08/2022
27
Startup
Adjustments to the label material
