12
OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi
EN
SELECT PREMIUM, EXCLUSIVE AND LUMISPA
In order to keep the pool water warm, the pump circulates the water through heaters.
In the
READY
mode, the pool maintains the set temperature and heats up the water as necessary. In the
REST
mode, the pool heats up the water only during set fi ltration cycles. In the
REST
mode, the pool
display may not necessarily show the pool temperature. The temperature will appear by starting up
Jets 1
JETS 1
and by returning to the main view.
The mode can be switched by choosing the
Heat
HEAT
icon in the
Settings
SETTINGS
menu. The
Ready
and
Rest
modes can be switched by pressing the
HEAT MODE
bar, the
Ready/Rest
modes change. To return to
the main view, press the back symbol . The chosen mode symbol, =
READY
and =
REST
, are
shown in the main view at the left side of the status bar.
MODES
The pool has two different settings for temperature ranges. You can set a separate temperature for each
of them. In the upper temperature setting (
High
) the temperature can be set between 26,5 °C and 40 °C.
This setting is best suited for use when you want to keep the pool always ready for use. In the lower
temperature setting (
Low
) the temperature can be set between 10 °C and 37 °C. The lower temperature
range is best suited for use when the pool is not used for an extended period of time and you do not
want to maintain a high temperature.
The temperature range setting is changed by selecting the
Heat
HEAT
icon in the
Settings
SETTINGS
menu.
The
High
and
Low
settings are selected by pressing the
TEMP RANGE
bar, then the
High/Low
mode
changes. To return to the main view, press the back symbol . The selected temperature range
symbol, =
HIGH
and =
LOW
, are shown in the main view at the left side of the status bar.
LOWER AND UPPER TEMPERATURE RANGES
Filtration cycle 1 is factory set to run from 8:00 pm to 10:00 pm. The starting point and duration of the
fi ltration cycle can be changed by selecting
Filter
FILTER
in the
Settings
SETTINGS
menu. When in the Filter
FILTER
view, fi rst press the time and then modify it with the arrow keys. Save the changes by pressing the
Select
-symbol .
Filtration cycle
is factory set to run from 8:00 am to 10:00 am. You can change the second fi ltration
cycle’s start time and duration in the same way as the fi rst fi ltration cycle. Save the changes by
pressing the
Select
-symbol .
In normal use, we recommend setting two 2-hour fi ltration cycles per day. In this case, the interval
between the start times of the fi ltration cycles must be 12 hours. For example, the fi ltration cycles
can be set the factory set periods 8:00–10:00 pm and 8:00–10:00 am.
PLEASE NOTE! If you use the
pool more frequently than three times per week, the length of the fi ltration cycles must be
increased .
FILTRATION CYCLES
The service mode
(HOLD)
can be used to stop the pump when carrying out small-scale servicing work,
for example. The service mode is activated by choosing
Hold
HOLD
in the
Settings
SETTINGS
menu. The service
mode runs for 60 minutes by default, but it can be interrupted manually by pressing the back symbol .
SERVICE MODE
The pool has an automatic preset cleaning cycle. The cleaning cycle starts when the pump has been
turned off for at least 30 minutes. You can fi nd the cleaning cycle settings in the
Settings
SETTINGS
menu, by
pressing the
Cleanup
CLEANUP
symbol.
CLEANING CYCLE
