Novitek EXCLUSIVE KIILO, Installation And Operation Manual

22

OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi

EN

MODES

The pool’s LED lights can be turned on by pressing the 

LIGHT

 button 

5

. To turn off the lights, press the 

LIGHT

 button 

5

 again. The pool’s LED lights have different colors and light modes. To change the light 

mode, turn off the LED lights and immediately turn them back on. The LED lights turn off automatically 

four hours after being turned on.

LED LIGHTS

In order to keep the pool water warm, the pump circulates the water through heaters. In the 

READY 

mode, the pool maintains the set temperature and heats up the water as necessary. In the

 REST 

mode, 

the pool heats up the water only during set filtration cycles. In the 

REST

 mode, the pool display may 

not necessarily show the pool temperature but the text  

RUN

 | 

PUMP

 | 

FOR

 | 

TEMP

 | 

-- -- 

-- --

. instead.

To change the mode, first press the 

MENU

 button 

3

 repeatedly until you see 

MODE

 on the display. 

Choose the desired mode by pressing the 

WARM

 button 

1

 or the 

COOL

 button 

2

. Exit the menu by 

pressing the 

MENU 

button 

3

. 

PLEASE NOTE! The chosen mode is shown at the bottom of the display .

To lock the pool’s control panel, first press the 

MENU

 button 

3

 repeatedly until you see

 LOCK

 on the 

display. After this, lock either the water temperature settings

 (TEMP) 

by pressing the 

WARM 

button 

1

 or the whole control panel 

(PANL) 

by pressing the 

MENU 

button 

3

 again. Change the setting (ON/

OFF) by pressing the 

WARM

 or 

COOL

 button 

1 2

. Save your choice and exit the menu by pressing the 

MENU 

button 

3

.

To open the keylock, press the 

WARM

 button 

1

 while simultaneously calmly pressing the 

MENU 

button 

3

 twice.

KEYLOCK

The service mode 

(HOLD) 

can be used to stop the pump when carrying out small-scale servicing work, 

for example. The service mode lasts for 60 minutes. To start the service mode, first press the 

MENU

button 

3

 repeatedly until you see 

HOLD 

on the display. After this, press the 

WARM

 button 

1

. The 

display now reads   

HOLD

 | 

ING

 | 

FOR

 | 

0:60 

(the running timer shows the remaining time for 

which the pumps will be disabled).

SERVICE MODE

The time must be set immediately after the pool’s installation, as the correct time is important for the 

functionality of the filtration cycles. To set the time, first press the 

MENU

 button 

3

 repeatedly until 

you see 

TIME 

on the display. After pressing the 

WARM

 button , you can set the time with the 

WARM

and 

COOL

 buttons 

1

2

. Move on to the next phase by pressing the MENU button 

3

. 

PLEASE NOTE! If the pool loses power or the power is turned off, the time must be reset .

SETTING THE TIME

To turn the display, first press the 

MENU

 button 

3

 repeatedly until you see 

FLIP

 on the display. After 

this, you can turn the display with the 

WARM

 and 

COOL

 buttons  

1

2

. 

TURNING THE DISPLAY 

STANDARD