Novitek EXCLUSIVE KIILO, Installation And Operation Manual

OY NORDIC SPA LTD | Tehdaskatu 7, 24100 Salo | www.novitek.fi

23

EN

Filtration cycle 

1

 is factory set to run from 8:00 pm to 10:00 pm. To change the filtration cycle’s start 

time and duration, first press the 

MENU

 button 

3

 repeatedly until you see 

FLTR1

 on the display. After 

this, press the 

WARM

 button 

1

 twice and then change the start time of the filtration cycle with the 

WARM

 and 

COOL 

buttons  

1

2

. Move on to the next phase by pressing the MENU button 

3

. After 

setting the start time, set the duration of the filtration cycle in the same way.

Filtration cycle 

2

 is factory set to run from 8:00 am to 10:00 am. To change the filtration cycle’s start 

time and duration, press the 

MENU

 button 

3

 repeatedly until you see 

FLTR2 

on the display. You can 

change the second filtration cycle’s start time and duration in the same way as the first filtration cycle.

In normal use, we recommend setting two 2-hour filtration cycles per day. In this case, the interval 

between the start times of the filtration cycles must be 12 hours. For example, the filtration cycles can 

be these factory set periods 8:00–10:00 pm and 8:00–10:00 am. 

PLEASE NOTE! If you use the pool more frequently than three times per week, the length of the 

filtration cycles must be increased.

FILTRATION CYCLES

The pool has two different settings for temperature ranges. You can set a separate temperature for 

each of them. The selected temperature range is shown at the bottom of the display.

In the upper temperature setting (

RANGE

) the temperature can be set between 27 °C and 40 °C. 

This setting is best suited for use when you want to keep the pool always ready for use. In the 

lower temperature setting (

RANGE

) the temperature can be set between 10 °C and 27 °C. The lower 

temperature range is best suited for use when the pool is not used for an extended period of time and 

you do not want to maintain a high temperature.

To change the temperature setting, first press the

 MENU

 button 

3

 repeatedly until you see 

TEMP

 on 

the display. Choose the desired mode by pressing the 

WARM

 button 

1

. Save the setting and exit the 

menu by pressing the 

MENU

 button 

3

.  

PLEASE NOTE! The selected setting is shown at the bottom of the display .

LOWER AND UPPER TEMPERATURE RANGES

The pool has an automatic preset cleaning cycle. The cleaning cycle starts when the pump has been 

turned off for at least 30 minutes.

CLEANING CYCLE

STANDARD