5
Pressing Cylinder HP 95
2.19
Insert and fully seat the locating washer (17) into the cap screw (8).
2.20
Place the washer (18) and the spring (13) on to the cap screw (8).
2.21
Insert the cone of the pin (7) into the locating washer.
2.22
Screw the assembled inlet pressure valve into the cylinder (3).
2.23
Fit the thrust pin (9).
2.24
Only for HP’s with hand switch:
•
Screw the adapter (4/31830) into the cylinder (2) and place the shims (5/31830) on to the
adapter (4/31830).
•
Fit hand switch (27) on adapter (4/31830).
•
Fit cup washer (6/31830) on adapter (4/31830).
•
Tighten hand switch with lock nut (3/31830). The groove in the nut (see enlargement)
must point towards the hollow side of the cup washer.
•
Arrest the lock nut (3/31830) by tightening grub screw (17/31830).
2.25
Insert plug connector and tighten it.
Summary of Contents for HP 300
