NVAHD-1DN3102H/IR-1- ver. 1.0 - User’s manual
All rights reserved © AAT Holding S.A.
9
SETTINGS
4.1. Power supply connection
NOTE: Device should be supplied only from a power sources whose parameters are in accor-
dance with those specified by producer in the camera’s technical datasheet. Therefore, it is for-
bidden to supply the camera from power sources whose parameters are unknown, unstable or
not meeting the producer’s requirements.
5. SETTINGS
The camera has an OSD menu displayed in the foreground of image. During normal operation
status information can be displayed on the image. To navigate menu and make changes please use
joystick located on the bottom of the camera:
To enter the menu, press the joystick, which sends
ENTER
command to the device. To choose
submenu, select the
UP, DOWN (UP, DN)
directions. If the sub-menu contains the symbol
that
indicates the opportunity to enter to the settings by pressing the
ENTER
key. To change the parame-
ters of selected items, press
LEFT, RIGHT
buttons.
To exit the menu and saves changes, select
EXIT
and next select
SAVE & END.
By selecting
RESET
you can restore the factory settings, and
by selecting
NOT SAVE
you can exit the menu without saving changes. To exit the submenu, select
RETURN
and press
ENTER.
Choosing (with left or right button)
SAVE & END
in the
RETURN
position saves changes and closes the menu.
NOTE:
In case of the image failure after connecting camera, or video loss due to changes in the menu,
it is possible to restore the factory settings. Following procedure is also recommended when
camera menu is not working. To restore factory settings:
1. Turn the power off and on again.
2. If the picture does not appear, perform the following sequence of joystick keys:
press ENTER, UP, RIGHT, press ENTER.
Successful completing these steps restores factory settings (AHD 720p, PAL).
video
12V DC +/- 10% power supply
video
(GND)
+
- (GND)
