NVIP-2DN7460H/IRH-
2P User’s manual ver.1.0 (short form)
All rights reserved © AAT Holding S.A.
10
2.2. Connecting power supply to the camera.
The camera can be supplied by using RJ45 network socket. To run NOVUS IP camera you have to
connect Ethernet cable between camera and network switch with PoE support (IEEE 802.3at). You can
also use a power injector compatible with IEEE 802.3at standard. Camera can be also supplied by using
power supply adapter compatible with camera parameters (description of the power connector is placed
in the 2.1 Chapter of this user’s manual).
Information:
Power supply adapter is not included. Please use power adapter with parameters specified in user’s
manual.
CAUTION!
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
CAUTION!
It is forbidden to use as the camera power source PoE equipment (adapters, etc.) not compatible
with IEEE 802.3af standard (items called “passive PoE power supply”). Damages that results
from the usage of improper power supply source are not covered by the warranty.
2.3. NVIP-2DN7460H/IRH-2P
mounting
To mount a camera please follow the instructions below:
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket’s
base screw holes as a pattern, mark future drilling holes for screws using a punch.
Drill holes in accordance with previously done markings and base hole placement.
Mount the camera with bracket on the ceiling/wall with three supplied self tapping screws.
Unscrew Screws
„A”
and „
B
” adjust the location and angle of the camera, and tighten the
screws.
NOTE:
Please note that the wall or ceiling must have enough strength to support the IP Camera.
START-UP AND INITIAL CAMERA CONFIGURATION
A
A
B
