NOVUS AUTOMATION
6/6
6
BATTERY REPLACEMENT
Replace battery with Panasonic lithium battery
Part No. CR 2032 only.
Usage of another battery may present a risk of
fire or explosion.
Replacement procedure is described as follows:
•
Remove the plastic cover.
Fig. 10
•
With a small screwdriver, carefully remove the circuit board and
battery
Fig. 11
•
Insert a new battery and reattach the electronic board in the
cabinet.
Fig. 12
•
Carefully connect the USB connector into the housing with the
battery downward.
Fig. 13
7
MOST FREQUENTLY FOUND PROBLEMS
The LED is not flashing
: The LED flashing light is intentionally weak
and it can be difficult to see it in clear environments. Certify it is really
not flashing.
Communication with the device fails:
Make sure the COM port is selected correctly and there is no other
program using the same port during communication attempts.
Make sure there is no physical obstacle blocking the infrared signal.
Make sure the cable is well connected to the PC port.
Make sure the port selected does not present any problem.
8
SPECIAL CARE
When handling the device and its battery, observe the following:
•
When the device is opened, avoid touching the electronic
components and the printed circuit board to avoid electrostatic
discharge damages.
•
Pay close attention to battery polarity.
•
When closing, the cover and its sealing must be mounted
correctly and carefully to ensure the enclosure sealing.
•
Used batteries must be disposed in accordance to local
regulations. Don’t try to recharge, dismount or heat, since
explosion may occur.
9
WARRANTY
Warranty conditions are available on our web site
www.novusautomation.com/warranty
.